Kia Sorento Trailer Wiring Installation And Review Videos

Trailer Wiring Harness Installation - 2008 Kia Sorento- Video

Today on our 2008 Kia Sorento, we'll be installing the Curt Custom Fit Vehicle Wiring, part number 56146KIT. To begin our installation, we'll first need to remove some interior trim components. We'll raise the rear cargo cover. Once we raise up the rear cargo cover, we'll then remove the carpeted quarter panels. We'll go ahead and remove those and set them aside for installation later. Then raise the rear cargo tray, to do this we'll first need to remove the five fasteners across the back. To remove the rear fasteners, you'll simple screw out the center section with a Phillips screwdriver and then remove the two piece fastener. more

10/7/2014 4:32:38 PM

Trailer Wiring Harness Installation - 2015 Kia Sorento 56146KIT- Video

Today on our 2015 Kia Sorento, we'll be installing the Curt Circuit Protected Taillight Wiring Kit, with four pole connection, part number 56146KIT. To begin our install, we'll first open up the rear hatch. We'll need to remove the taillight assembly. Once we open up the hatch, we'll locate the fasteners for the taillight assembly, remove them and pop the taillight assembly out. We'll just leave the taillight assembly hang there, as we'll be making connection with the manufacturer's wiring. The Curt wiring harness is a circuit protected converter with a power wire, passenger side turn signal for the green, running light circuit, driver's side turn signal, brake signal and ground. Now we'll move over to the passenger side, go ahead and remove the taillight assembly. more

8/20/2014 10:53:39 AM

Trailer Wiring Harness Installation - 2014 Kia Sorento 119147- Video

Today on this 2014 Kia Sorento, we're going to install part number 119147KIT and then we're also going to use part number 118151. Fist thing we're going to do is open up the back hatch. Then we're going to go ahead remove the tail lights. There are two screws we have to remove for each tail light. Remove the two and then we can pop it loose in the bodywork. Then we'll go ahead and disconnect the wire harness from the tail light. There's a small tab we have to push down and then we're going to go ahead and release it from the wiring harness. more

1/20/2014 7:44:23 AM

Trailer Wiring Harness Installation - 2008 Kia Sorento c57674- Video

Today, on our 2008 Kia Sorento, we'll be adding the adapter four-pole to seven-pole with test lamps, part number C57674. After this application, we'll only be connecting the ground running lights and turn signals. To begin our install, we'll first mount the seven-pole the bracket onto the seven-pole connector. We'll use the hardware provided with the seven-pole kit.Now, for this application, we'll only be using the four-pole connector, so were going to go ahead and fold under the extra wiring and tape it up to clean up our install look. Now, with that done, we'll go ahead and add the Draw Tite no-drill mounting bracket, part number 18136. Once secured, we'll attach the no-drill mounting bracket to the hitch using the worm clamp provided.Now, with that secured, we'll go ahead and route the seven-pole wiring up over the hitch and secure it to the fourth pole connector already on the vehicle. more

5/13/2013 3:41:13 PM